Take a fresh look at your lifestyle.

Careful About Your Hot Water Tank for Bathroom in Plumbing

27

Make Your Choice of Hot Water on Demand System

How wonderful it would be if you could get hot water instantly at the turn of a tap; and would be able to save money on utility bills as well. Well, it is a dream come true, and tankless water heaters are going to make it happen.

When you install a tankless water heater system you will be saving 40 percent on your water heating costs annually; the system is going to serve you faithfully for more than twenty years without giving you trouble, and you will be getting hot water in seconds on turning the faucet on.

With so much to offer, you can’t resist the temptation of installing a tankless water heater system in your home. The best part of it is that you have a choice to make from the two systems that are available. You can either choose the whole house tankless water heater or the point-of-use water heaters.

Watch out for any Plumbing Problems in your house

There are some problems related to plumbing that can be taken care of quite easily by you, but there are some issues that require the professional plumber to take care of. The professional is recommended because some smaller issues, at first sight, may seem minor but when you try to do it on your own, the issue might escalate into something that will involve a lot of expenses and harassment.

As a homeowner, you will have to keep an eye on the tell-tale signs of plumbing problems so that you are able to detect plumbing issues at its initial stage and take appropriate action in order to avert bigger problems. An eye on the water bill is to be kept in case there is a sudden spike in the water bill.

The appliances will start giving funny noise. Also, keep an eye on any wet spots that may appear on the walls or the floor; mold on surfaces; these are indications of plumbing line leaks inside the wall or under the floor. Leaks can also be detected when you find puddles of water under the kitchen or bathroom sinks.

How to Conserve Water

Conserving water is now a necessity rather than a choice. The demand for freshwater has increased thus depleting the underground water as well. Therefore you should do all you can to conserve as much water as possible.

A bathroom is a place where we use water to the maximum. Ensure there is no leak anywhere whether in the toilet or the faucet. Check your water meters periodically, if there is a spike in your water bill assume there is a leak.

Install water-saving devices in the toilet, showerheads, and faucet aerators. For heating water switch over to tankless heaters. Insulate hot water pipes to prevent heat escaping. Turn off the tap when you are brushing teeth or shaving; use a glass of water to rinse your brush or razor.

Choice of Water Heaters

Selecting a water heater is a serious issue as you will have to take into account a few factors that are vital. The water heater should be able to provide enough hot water and should contribute towards the conservation of energy and saving of money. When you consider such factors, other factors like the size, power source, and energy efficiency also have to be deliberated on.

Due to its low upfront cost, conventional storage water heaters is the preferred water heating system for the home. In this system, a storage tank with a capacity from 20 to 80 gallons is used to store hot water at a central location in a standby mode.

How to Determine Water Heater Sizing

Choosing the right size of the water heater is as important as choosing the right water heater. If you make a mistake you will either be stranded with hot water running out too early or will be seeing your energy bill going through the roof. Proper sizing will keep you warm and also save you money. And proper sizing is no big deal, with a little bit of calculation you can easily estimate the sizing.

For sizing a traditional water heater all you have to do is choose the hour of the day when practically every plumbing fixture and household equipment are spewing hot water. The shower will consume around 2.2 gallons per minute; multiply this with the number of showers taken with the duration of each shower.

Leave A Reply

Your email address will not be published.